3200 Series fitting instructions

Hold respirator in hand with molded nose contour (narrow end) at finger tips, allowing head harness/halo to fall below hand.

Place respirator under chin with molded nose contour
(narrow end) up.
Nose cushion must be uncreased inside respirator.
Pull head harness/halo to top of head so it rests on the crown.

Adjust head harness/halo to provide a comfortable and secure fit.

Each time before entering a contaminated area perform a user seal check.
Cover front of respirator by cupping both hands.
INHALE SHARPLY.
A negative pressure should be felt inside respirator. If any leakage
is detected at respirator edges, reposition respirator and/or select another size. Repeat until sealed properly, otherwise see your supervisor. Entry into a contaminated area with an improper fit may result in sickness or death.