EZ-ON^® strap fitting instructions

1

2

3

4

Hold respirator in hand with molded nose contour (narrow end) at finger tips, allowing head harness to fall below hand.

Place respirator under chin with molded nose contour (narrow end) up.
Nose cushion must not be creased inside of respirator.
Pull head harness to top of head so it rests at the crown.

Adjust tension by pulling on strap within the head harness to provide a tight and comfortable seal.

Each time user enters contaminated area , perform a user seal check.
Cover front of respirator by cupping both hands.
INHALE SHARPLY.
A negative pressure should be felt inside respirator.
If any leakage is detected at respirator edges, adjust straps by pulling back along the sides and/or reposition respirator. Repeat until sealed properly, otherwise see your supervisor. Entry into a contaminated area with an improper fit may result in sickness or death.